Tweet
Here are some pics of a newer Ford Mustang Bullit that Richard Lin (OctaneGuy), and I will be working on this saturday. I'll post the full writeup once we complete the detail.
Today I had just enough time to do the trunk lid, as well as a test spot of the rear quarter panel which had some nasty water spot etchings.
This is what I started with:
Note the right side was compounded using M105 and a wool pad, one pass.
Here are some afters:
Me using my halogen instead of the camera flash in this pic.
If you'll notice in this pic you can see where I wetsanded the brake light cover. This vehicle lives outdoors in the desert and the sun chewed the plastic up.
Here is a 50/50 of the water spots I was talking about:
More to come, so enjoy.
Today I had just enough time to do the trunk lid, as well as a test spot of the rear quarter panel which had some nasty water spot etchings.
This is what I started with:
Note the right side was compounded using M105 and a wool pad, one pass.
Here are some afters:
Me using my halogen instead of the camera flash in this pic.
If you'll notice in this pic you can see where I wetsanded the brake light cover. This vehicle lives outdoors in the desert and the sun chewed the plastic up.
Here is a 50/50 of the water spots I was talking about:
More to come, so enjoy.
Polishing Paint removes the stress in my life, and the swirls on my car. 
Comment