Polishes: Meguiars compared to 3M & Einszett?

[Balance1m]

I am a new forum member; have been reading as much as possible.

I have been a car care enthusiast for a while, but just got into the PC machine mode recently.

I have used the following for the compound/polish/glaze stages with good results:

Einszett:
Ultra Paint Polish,
Paint Polish &
Metallic Polish

AND

3M Perfect-it III:
5933 Compound,
5937 Machine Glaze &
5941 Finishing Glaze

I want to try the Meguiars Line and need a comparable line-up. Can you compare:

UPP to 5933 Compound to what Meguiars - #84?

PP to 5937 MG to what Meguiars - #83?

MP to 5941 FG to what Meguiars - #80?

LSP will be NXT or #26

I have the 8006 polishing pads. I read Mike's recommendation to AVOID the 7006 cutting pad on the PC. So should I use the 8006 for the compound and polish step and use a 9006 or 8006 for the glaze?

Cars' paint condition vary from a 2002 in great shape to a 1997 with moderate swirls.

Thanks again for all of your tips and advice.

[Bill D]

I'm partial to the 1z line especially for use on my Audi paint.

Biggest advantage: very user friendly, only 3 polishes, good by
hand or machine--delivers RESULTS!


Biggest disadvantage: Contains waxes, which can disguise
whatver defects it might not have
removed, so youll need a isopropyl
alcohol mix to remove them or if
you want to top with a sealant
(otherwise won't bond)

[Mike Phillips]

Hi Balance1m

Welcome to Meguiar's Online!

Just to note, I did receive and read you e-mail asking these same questions, but behind the scenes, I'm often working on multiple e-mails, threads and projects and cannot always answer all e-mails right away, especially ones like your's that require some thought.

I will try to shed some light on some of your questions.

Mike

[Balance1m]

I will note though that the 3M stuff is rated for rotary only.

I am using a PC currently. Maybe a Makita rotary later, no need at the current time.

Thanks, Jayrotary only