I'm about to start a fiberglass project in my Jeep for a speaker enclosure, and had a couple of questions about the Mold release waxes.
I'm using the Tap, and glass method to build my speaker box. (Lay down blue painters tape, then use resin and fiberglass over top, then pop out the shee and stretch fleece over the speaker ring)
My questions is, could I use a mold release wax to ensure that resin would have less of a chance of sticking to the painters tape? If so, which wax should I use?
Thx Guys.
I'm using the Tap, and glass method to build my speaker box. (Lay down blue painters tape, then use resin and fiberglass over top, then pop out the shee and stretch fleece over the speaker ring)
My questions is, could I use a mold release wax to ensure that resin would have less of a chance of sticking to the painters tape? If so, which wax should I use?
Thx Guys.
Comment